• Reasonable setting method of injection molding pressure holding

  In injection molding, the process has two main stages. In the first, 90% - 99.9% of plastic fills the mold. In the second, the product is compacted, which is vital for surface and dimension quality. T

  2025/01/26 pressure holding

• What is the exhaust of the mold cavity? What is sufficient exhaust

  Significance of VentingVenting is crucial, especially for thin - walled products and areas far from the gate. For small or precision parts, venting is also essential. It prevents surface burns, short

  2025/01/24 Exhaust of the mold cavity

• Knowledge of pressure regulation during plastic injection molding

  In injection molding, whether with hydraulic or electric machines, all motions generate pressure. Proper pressure control is crucial for quality products.Pressure Regulation and Measurement SystemHydr

  2025/01/22 Pressure Regulation in Plastic Injection Molding

• Injection molding is not complete how to do?

  波音彩票 Adjusting the production process is crucial for enhancing product quality and output. Given the short injection - molding cycle, poor process control will yield numerous defective products. When makin

  2025/01/20 Injection molding problems

• What is the closed-loop system of injection molding machine?

  The injection molding control system is a cyclic process that contains a set of preset programs. The next cycle will run only when certain conditions are met. The inspection and monitoring of these co

  2025/01/18 closed-loop system

• Plastic gear injection molding process and material analysis

  波音彩票 Development Trends of Plastic GearsPlastic gears are advancing towards larger sizes, more complex geometries, and higher strength. High - performance resins and long glass fiber - filled composites dr

  2025/01/15 Plastic gear injection molding

• The segmented principle of multistage injection molding

  波音彩票 I. Flow Characteristics of Plastic MeltScrew - Propelling PhaseInitial Segment:Usually starts from the beginning of injection molding. Its main function is to enable the plastic melt to stably enter t

  2025/01/06 Multistage injection molding

• Quality standards for conventional injection molded parts

  波音彩票 This standard mainly specifies the inspection and testing methods for various plastic products in injection molding production. It is applicable to the inspection of general injection - molded product

  2025/01/03 injection molded parts Quality standards